1603-3.0-5 FL GA20 TOP R15 UHM20 HPX
0
- GSI Part
- 7005-211377
- Series
- CUT1600
- Operation/Geometry
- Front Turn
- Chip Breaker
- GA20 Chip Breaker & Top Wiper
- Execution
- Left Handed Standard Cut
- Grade / Coating
- UHM20 HPX
- Depth Of Cut (c)
- 5 mm
- Width Of Cut (a)
- 3 mm
- Relief Angle (β)
- 52°
- Nose Radius (r)
- 0.15 mm
- Edge Sharpness
- Sharp Cutting Edge
- (γ)
- 35°
- (δ)
- 3°
- Leading Cutting Edge Flat (b)
- 1.6 mm
CUT1603 GA20 TOP Front Turning Inserts
With Type-GA20 Chip Control & TOP Wiper Geometry
multidec® 1603 turning inserts are designed for front turning operations on Swiss-type CNC machines. Perfectly designed for the smallest of Swiss machines the 1600 series excels at work under .125in diameter. Tough carbides combined with a variety of coatings enhances tool life in tough materials typically machined in Swiss-type applications.
- HPX Coated
- Front turning operations
- 3mm (.1181in) insert widths
- TOP wiper geometry - Improved surface finish
- Type-GA20 chip control: Based of the multidec TOP insert technology, this optimized version enables turning in three directions. Perfect chip control is maintained during facing, turning, grooving, and back turning. Inherited from the TOP insert technology, the GA20 enables up to 100% higher feed rate.
NOTE: Not recommended for use in plastics and titanium due to lower tool life in these materials. Check speeds and feeds for proper usage.